Automotive Tank Sealing Kit treats tanks of a capacity of 30 litres. It seals tank interiors made of steel (also alloys), aluminum, stainless steel, copper, brass and plastics such as carbon, GFRP, Kevlar, polyester or vinyl ester. Even new tanks with smooth inner surfaces can be sealed with this single-component tank sealing resin. Note: The tank sealing resin cannot be used on tanks made of polyethylene or polypropylene, since these materials cannot be coated permanently. Transparent inner coating that prevents rust formation on the inside tank surfaces and provides long-term protection against corrosion in any tank. The Single-Component Tank Sealing Resin is resistant to leaded and unleaded fuel, ethanol/petrol blended fuels such as E5, E10 and E85, pure ethanol, pure petrol (gasoline), two-stroke mixtures, diesel fuel, aviation fuel, motor oil, transmission oil, hydraulic oil, mineral oil, synthetic oil, two-stroke oil, brightstock, coolant, and some additives. As opposed to most two-component sealing compounds, the Single-Component Tank Sealing Resin does not become brittle and permanently retains a minimum amount of flexibility. This is very important as it means the inner coating bonds reliably even in case of later damage to the tank due to vibrations or minor accidents. Use the kit after careful cleaning and according to the instructions. All previous coatings must also be removed from the inside of the tank. The operations can be carried out in an open, dry "garage environment", at a temperature above +18°C (recommended: 20-24°C). Note: no coating will reliably adhere to a poorly cleaned surface. It is very important to use the recommended materials and follow the kit instructions. The kit contains: Tank Cleaner 1L, rust remover 2x 250ml. Tank Sealer 250 ml, plus instructions.