Create flares in sheet metal up to 1/8" thick using the Eastwood Dimple Dies.
Includes both Male and Female Dies
Form clean 45° flares in up to 1/8” thick steel
Made with high-strength Chrome Moly steel
Machined to close tolerances
Simply drill the recommended hole size in the metal that you desire to dimple, then use a press to do the work. Made from heat treated Chrome Moly steel, these dies are built to last. Hole and Flare Size:
1/2" Die - Requires 1/2" hole - Flare Width 0.7" -
1" Die - Requires 1" hole - Flare Width 1.4" -
1-1/2" Die - Requires 1-1/2" hole - Flare Width 2.15" -
2" Die - Requires 2" hole - Flare Width 2.85" -
2-1/2" Die - Requires 2-1/2" hole - Flare Width 3.5".
Metal Flaring Capacity:
Mild Steel: 1/8”.
Aluminum: 1/8”.
Stainless Steel: 3/32”.
Tools Required (not included):
• A set of sharp, high-quality metal saws in sizes corresponding to those in the Die Set.
• A 20 Ton Hydraulic Shop Press or equivalent.
Outside Diameter Specification:
1/2" Die - OD: 34.8mm.
1" Die - OD: 56.2mm.
1-1/2" Die - OD: 75mm.
2" Die - OD: 101mm.
2-1/2" Die - OD: 124mm.